JAG Arms Extreme Active Braking MOSFET with wiring

Extreme active brake with wiring

- professionally designed and manufactured mosfet with motor active braking with 500mm long wires on each side for airsoft electric guns (AEG)
- four high quality 1,5qmm (AWG16) power wires covered with silicon insulation and two 0,25qmm (AWG24) signal wires
- If you want to use your own wires, choose device without wiring.
- Active brake uses the excess energy from the motor to stop it. The braking effect is the most powerful with high torque motor
- in weapons with very high rate of fire (ROF) active brake solves multiple shots in semi mode
- in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechbox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF)
- in auto fire mode piston stops in random position due the mechbox design. But this stopping is much faster with active brake
- Active brake increases gun rate of fire and battery holds longer
- no sparking on switch contacts
- device has voltage stabilization for switch mosfet, mosfet is fully opened and makes less heat
- specified for common batteries up to 17 V (Ni-xx 8.4V - 14,4V, li-po 7.4V - 14.8V, li-fe 9.9V - 13.2V)
- designed for maximum spring M170
- switching mosfet handles up to 2.5 times bigger currents than it's cheaper variant
- 5 times better switch on resistance = lower mosfet heating
- massive cooler for heat dissipation, it is glued to mosfet
- braking mosfet handles up to 2.3 times bigger currents than it's basic variant
- doubled number of resistor for reducing braking effect = less resistors heating
- easy to understand 6 wires connection
- device size 53x21x13mm
- coated with lacquer, which protects device against water
- in package is heat shrink over device

WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!